Alliance Laundry Systems NX18BVPA6, Installation & Operation Manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Installation/Operation Supplement

9002062 (EN)

10

Mounting Bolt Installation 
(If Required)

Figure 3 

After the concrete has cured and the anchors are 
installed, proceed as follows:

1. Place the washer-extractor adjacent to the 

foundation. Do not attempt to move it by pushing 
on the sides. Always insert a pry bar or other 
device under the bottom of the frame of the 
washer-extractor to move it.

2. Place the washer-extractor carefully over the 

anchors. 

3. Put bolts through the machine in the anchors and 

fasten them. The diameter of the bolt must be 
minimum 1/2-13 or 12 mm.To level machine, fill 
the spaces between the machine base and floor 
with machinery grout. Grout completely under 
all frame members. Remove front and rear panels 
to gain access to all frame members. Force grout 
under the machine base until all voids are filled.

4. Remove the spacers carefully, allowing the 

machine to settle into the wet grout.

5. Position washers and locknuts on machinery 

anchor bolts and fingertighten to machine base.

6. After the grout is completely dry, tighten the 

locknuts by even increments – one after the 
other – until all are tightened evenly and the 
machine is fastened securely to the floor.

CFS485N

1

Base Frame

2

Bolt

3

Washer

4

Anchor Bolt/Plug

CFS485N

6 in. 

(152 mm)

1

2

4

3