Preventative Maintenance
Follow these guidelines to ensure the washer operates proper-
ly. Call for service if you observe any of the following: water of
any amount on the floor, an increase in operating noise or wa-
ter remaining in the wash basket after a cycle.
Frequency
Maintenance Proce-
dure
Monthly
1. Check all hoses and the
drain for leaks.
2. Check the lid switch for
proper operation.
3. Check to make sure the
washer is level.
4. Clean upper 2-3 inches of
wash tub. Fill washer with
warm water at highest
setting. Use an all-pur-
pose cleaner or a steel
wool soap pad.
Every six months
1. Clean the filter screens in
the fill hoses.
Every five years
1. Have a qualified service
technician conduct gener-
al preventative mainte-
nance on the washer to
ensure it operates proper-
ly.
2. Replace the fill hoses.
Table 4
Reinstallation of Shipping Materials
You must install the shipping brace and shipping plug any time
the washer is moved.
Shipping Brace
The shipping brace in the lid opening should be saved and re-
installed whenever the washer is moved. To reinstall the brace,
open the washer lid and place the brace over the washer agi-
tator, placing the back of the brace into the lid opening first.
Shipping Plug
The plastic shipping plug should be saved and reinstalled any
time the washer is moved. The plug fits into two openings: The
base opening and the shipping plug opening on the bottom of
the movable pivot dome. The plug MUST be inserted into both
openings to prevent damage to the washer. In order to accom-
plish this, the shipping plug opening must be directly lined up
with the base opening.
1. Shipping Brace
2. Shipping Plug Opening
3. Base Opening
4. Shipping Plug
After the shipping brace has been installed in the lid opening,
tilt washer back enough to access base opening.
Insert shipping plug into base opening and, using the palm of
your hand, push shipping plug into washer until it snaps into
shipping plug opening.
Motor Overload Protector
The internal motor overload protector will stop the motor auto-
matically if there are too many clothes in the washtub or if a
failure has occurred within the machine. The overload protec-
tor will reset itself in two or three minutes and the motor will
restart automatically.
If the overload protector stops the motor again, remove the
washer from use and call a service person to correct the prob-
lem.
Maintenance
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
21
Part No. 204807EN
Summary of Contents for Speed Queen TC5000WN
Page 2: ......
