2. Install standpipe adapter onto drain hose only if standpipe di-
ameter is 2 inches [51 mm] or less.
3. Place the drain hose into the standpipe.
IMPORTANT: To prevent siphoning, do not place
any ribbed portion of the drain hose into the stand-
pipe.
4. Remove the beaded strap from accessories bag and place
around standpipe and drain hose, approximately 12 inches
[300 mm] down from the top of pipe. Refer to
a. Insert the end of the beaded strap into the larger hole
found on the end of the strap.
b. Tighten to desired fit.
c. Lock strap in place by pulling beaded strap into the ta-
pered smaller opening of the beaded strap end. A distinct
snap noise should be heard once the strap is properly seat-
ed.
d. Pull on the strap once locked in place to ensure beaded
strap is properly installed. This will prevent the drain hose
from dislodging from drain receptacle during use.
TLW2341N_SVG
4
5
3
2
1
1.
Ribbed Portion of Drain Hose
2.
Beaded Strap
3.
Standpipe - 2 in. [51mm] or 1-1/2 in. [40 mm] Diameter
4.
36 in. [914 mm] Recommended Height
5.
12 in. [305 mm]
Figure 5
Low Standpipe Installation
If standpipe is lower than 36 inches [914 mm], you must install
No. 562P3 Siphon Break Kit. This kit is available (as optional
equipment at extra cost) through an authorized dealer or parts dis-
tributor. Installation instructions are supplied with the kit.
TLW2283N_SVG
2
1
3
1.
562P3 Siphon Break Kit
2.
Standpipe
3.
Drain Hose
Figure 6
Wall Installation
Check wall drain height. The recommended height for the drain
is 36 inches [914 mm].
Install standpipe adapter onto drain hose only if standpipe diame-
ter is 2 inches [51 mm] or less.
For installations of this type, the drain hose MUST be secured to
one of the fill hoses using the beaded strap from accessories bag.
Refer to
W329I_SVG
2
1
1.
Beaded Strap (tape if necessary)
2.
Standpipe Adapter (select models)
Figure 7
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
8
Part No. 204871ENR1
Summary of Contents for TC5003WN
Page 2: ......
