Control Panel
Power
Start
Pause
Cancel
Warm
Hot
Cold
Temp
Soil
Level
Load
Size
Large
Medium
Small
Medium
Heavy
Wash
Rinse
Spin
Light
Soak
Delicate
Second
Rinse
Pre-
Wash
TLW2234N_SVG
Spin
Normal
Eco
Perm
Press
Preset Cycles
Rinse
& Spin
Heavy
Duty
Signal
Digital Display
The two-digit display is used to show the time remaining in a cycle.
If the cycle time is over 99 minutes the control will display either
1H, 2H, etc., and then the additional minutes over one or two
hours.
The display also shows diagnostic codes.
Soak
In the lower right of the display, a single light will flash during any
soak portion of the cycle.
The soak light also will flash once each minute in Idle Mode. Idle
Mode is entered if no keypads have been pressed for five minutes
after a cycle is finished. Press the Power/Cancel keypad to exit this
mode
Cycles
The following cycle descriptions will help determine which cycle to
choose depending on the type of laundry being washed. The de-
scriptions are standard settings that may be modified using the
Selections and Options.
Heavy Duty
Use for sturdy items, like play or work clothes, towels, T-shirts, etc.
The wash time selection will depend on the type of fabric and the
amount of soil. For the best results when cleaning heavily soiled
items, use a higher soil level selection. Lightly soiled items require
less wash time.
Use the Prewash setting for extra heavily soiled items. During the
PREWASH setting, the washtub will fill with water, agitate for a re-
duced period of time and spin out.
Normal Eco
This cycle uses less water than the other cycles. It also uses less
hot water. This cycle is recommended for washing everyday cot-
tons and linens.
Perm Press
Use for permanent press items and synthetics. The final spin is a
low spin speed.
Delicate
Wash delicate items usually washed by hand on this cycle. A full tub
of water is recommended (even for small loads) to allow the deli-
cate items to move freely through the water. More water helps re-
duce fabric wear, wrinkling, and provides for a clean wash.
On this cycle, the agitation during the wash portion of the cycle is
not constant. The wash will alternate between periods of agitation
and then a short soak until advancing to the spin portion of the cy-
cle. All spin speeds are a low spin.
Rinse & Spin
Use to quickly rinse items. The rinse is followed by a high spin.
Spin
Use this cycle to extract water from wet items. The cycle uses the
high spin.
Selections
The following selections can be used to modify the currently chosen
cycle. The default selections will be lit after choosing a cycle.
Control Panel
Part No. 203183
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
11
Summary of Contents for TLW22C SVG
Page 2: ......