39201
39
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Troubleshooting
Coin Slide Operated and Non-Metered Models with the Number “8” or “9” in
the 4th Character of the Model Number
19. Error Mode
In Error Mode, the
IN USE
LED flashes to display fill and drain errors (refer to paragraphs below). Error Mode
can only be exited by powering down washer.
Fill Error
A Fill Error will occur if the tub does not fill within 62 minutes of the start of the cycle. A Fill Error is indicated
by the control repeatedly flashing the
IN USE
LED twice separated by a one and a half second pause until the
control is powered down. If Error Mode is turned off, the fill error will not occur and the control will continue
to wait for the fill level to be reached.
Drain Error
A Drain Error will occur if the tub is not empty after a spin cycle. A Drain Error is indicated by the control
repeatedly flashing the
IN USE
LED three times separated by a one and a half second pause until the control is
powered down. If Error Mode is turned off, the drain error will not occur and the machine cycle will advance
to the next cycle step as though the water had been pumped out.
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
