Water Reuse Connection
WARNING
Disconnect the machine power supply. When the
main switch is turned off, the inlet terminals of the
machine main switch are still under current.
W900
1. Drill out the protective screens of the water reuse inlet using a
drill bit of 0.59 in. [15 mm] diameter. Refer to
.
IMPORTANT: Do not pierce the screens open. It
could lead to blockage of the water channel.
1
CFD1215N
2
1.
Cable inlet for control of water reuse valve or pump
2.
Water reuse inlet
Figure 26
2. Connect the control of your reuse valve or pump onto the con-
ductor of inlet valve I5 or I7 provided by the manufacturer,
which will disconnect the valve in question from standard
function.
IMPORTANT: The manufacturer waives all responsi-
bility for malfunction of the washing machine if a
different valve than the specified I5 or I7 is used as
the water recycle valve.
3. Fit a cable bushing into the opening, and pull the cable
4. Connect the coil for control of the recuperated water inlet (the
coil is not supplied with the machine), operating voltage
208-240V 50/60 Hz.
5. Secure the cable so that it cannot be pulled out of the machine
or inlet valve.
Water Reuse Specifications
Temperature range, °F [°C] 41 to 194 [5 to 90]
Maximum pressure, PSI
[bar]
116 [8]
Connection - outside diam-
eter, in. [mm]
0.75 [19]
The hose and the connector must be resistant to chemical sub-
stances which are used for the washing process. It is also possible
to use a hose with enhanced performance such as the rubber
EPDM hose.
The water reuse system must be fitted with a filter which must be
regularly and thoroughly cleaned (based on water quality). This
cleaning prevents prolongation of filling up times and malfunc-
tion of water valves.
Reused Water Treatment
The reused water must be filtered before entering the water reuse
tank. A mechanical filter must be installed which filters off small
particles (fluff, buttons, paper, etc.) of sizes 0.0079 in. [0.2 mm]
or smaller. The denser the mesh, the better. There must also be a
filter installed on the pressure side of the pump. It is also possible
to install an additional, chemical filter. The manufacturer advises
to consult a specialist in filter systems.
Water Reuse Tank Properties
WARNING
It is prohibited to heat the water in the reuse tank.
This would disturb the temperature balance of the
washer and make the remaining chemicals in the re-
cuperated water more active, which would lead to
corrosion of the entire installation.
W901
The reuse tank must meet the following minimum requirements:
• The tank must be made according to national standards.
• Tank capacity varies depending on multiple factors, so it must
be calculated by an authorized engineer. The factors are:
• The number of washing steps per washer, in which the wa-
ter will be re-used.
• The programmable amount of water that will be re-used in
a washing step (to find this amount, please refer to the
Programming Manual).
• The number of washers that will deliver water to the re-
use tank.
• The use of recuperated water per washer.
The tank must have an overflow to the sewer. Water from the
sewer must not be able to flow back into the reuse tank.
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
42
Part No. D1598ENR10
Summary of Contents for UY105 PRO
Page 2: ......
