ALLIANCE 815, Owner'S Manual

8 

Console Functions and Descriptions 

POWER

 - Press to on.  Allow 

6-8 seconds while the 
electronics perform a self 
check prior to pressing other 

START/STOP

 - This button  

starts the treadmill belt 
moving.  There is a 4 second 
countdown built in as a safety 
feature to let you know the 
treadmill belt is about to start 
moving. 
Use the  START/STOP button 
also to stop your treadmill 
after your workout.  The belt 
will gradually come to a stop 
after pressing the button.  

PAUSE

 - Press to 

temporarily pause 
your workout 
while in use.  The 
treadmill is 
designed with an 
automatic power 
off feature after 5 
minutes in the 
pause mode. 

SPEED 

- Use to either 

increase (UP arrow) or 
decrease (DOWN arrow) 
the speed.  These buttons 
are also used while 
programming SPEED and 
TIME. 

INCLINE 

- Use to either 

increase (UP arrow) or 
decrease (DOWN arrow) 
the incline.  These buttons 
are also used while 
programming INCLINE. 

ONE TOUCH SPEED BAR 

- 

Use to either increase or 
decrease the speed.  Each 
number indicates MPH.  
Pressing one of the buttons will 
gradually increase or decrease 
the speed to the new setting. 

ONE TOUCH INCLINE 
BAR 

- Use to either increase or 

decrease the incline.  Each 
number indicates percent of 
grade.  Pressing one of the 
buttons will gradually increase 
or decrease the incline to the 

CONSOLE SAFETY KEY  

- Place the RED 

Safety Key here prior to turning power on.  
THE TREADMILL WILL NOT OPERATE 
WITHOUT THE SAFETY KEY ATTACHED. 
The safety key is equipped with a string and 
clip that will clip to your clothing.  This is an 
important safety feature that will automatically 
turn the power off if you should trip or fall 
while using the treadmill. 

PROGRAM BUTTONS

 - These buttons are used to 

access each of the three programs:  Fat Burn, Cardio, 
and Warm Up.  Each program has one preset program, 
and two additional custom programs in the P1 and P2 
mode.  See the “Program and Operating Instructions” on 
page 12. 

ENTER

 - Use 

the Enter button 
while setting 
program time, 
speed, and 
incline options.  
See page 12 for 
complete