Error Codes
Display
Description
Cause/Corrective Action
E Ht
Heater Error
If the heater is enabled and the water temperature has not reached the desired tempera-
ture selection within the programmable time, the control will indicate a heater error. If
this error occurs, the heater output will be turned off, and the cycle will continue. This
error will be cleared when the door is opened or any key is pressed.
E tE
Max Temperature
Exceeded Error
The control will continuously monitor the Machine Status for an indication that the
maximum water temperature is exceeded. When the cycle has been completed and if
the control has saved a Max Temperature Exceeded Error, the control shows error
E tE
for one minute, after the door is opened or a key is pressed.
E oP
Open Temperature/
Thermistor Sensor
Error
The Output Board will flag an Open Thermistor Error any time it senses a temperature
less than 0°F. It turns off the heater output for the remainder of the cycle. At the end of
the cycle, error code will be shown. Clears after 1 minute or with any key press.
E SH
Shorted Tempera-
ture/Thermistor
Sensor Error
The Output Board will flag a Shorted Thermistor any time it senses a temperature great-
er than 210°F. It turns off the heater output for the remainder of the cycle. At the end of
the cycle, error code will be shown. Clears after 1 minute or with any key press.
E SudS
Suds Lock Error
In the spin steps, if the control determines that there are suds in the machine after run-
ning all programmed Suds Routines, it will display a Suds Lock Error at the end of the
cycle after the door is opened. The control will continue showing this error code until
any key has been pressed or for one minute.
E Hd
Too Hot To Drain
Error
If water is detected to be too hot to safely drain, this error will be set. It is advised to
add a cool down step to the cycle after every heating step to avoid this error. Error will
display after door is opened in End of Cycle Mode. Clears after 1 minute.
E Ld
Water Leak Drain
Error
Error will display if there is a leak after the door is opened at the End of Cycle for 1
minute. Clears after 1 minute or until a key is pressed. If the water level has dropped
more than an acceptable amount in a during a water leak drain check, the control will
save a water leak drain error status and will continue the machine cycle. Immediately
upon detecting the error the right-most decimal point will be lit. This lit decimal point
can be cleared by pressing the START keypad 3 times in a period of 5 seconds or by
cycling the power to the machine.
E StHt
Slow To Heat Error
Non-Fatal Error that will appear during the running cycle without affecting the cycle.
Machine Error code is turned on for 15 seconds. Clears after a key is pressed.
E nFLo
No Water Flow Er-
ror
If the control does not reach a water level of 4 inches within the programmed time it
may mean the hose to the pressure sensor has a leak or no water is flowing into the
machine. The control will enter Machine Error mode. The control will first drain for
90 seconds and then turn off all outputs and turn on the Machine Error Tone for 15
seconds. To clear this error one of the following must occur: the machine must be
powered down, the Clear Fatal Error Keys must be pressed, or a Clear Fatal Error Net-
work command must be sent.
E oF
Overflow Error
The machine must be powered down, the Clear Fatal Error Keys must be pressed, or a
Clear Fatal Error Network command must be sent. This error is triggered when an un-
safe high water level is detected in the machine and water is unable to drain.
Table continues...
Error Codes
©
Published by permission of the copyright owner -
DO NOT COPY or TRANSMIT
113
Part No. 805405ENR5
Summary of Contents for BT3JGASG403UW01
Page 2: ......
