Service Door and Coin Vault Openings
The control will capture the times and dates of the last seven
openings of the Coin Vault and the Service Door. The informa-
tion is saved in memory. An open service door and a closed coin
vault combined with various keypad presses allows the control to
enter manual modes of operation if the Break-In Alarm is not on.
These modes include Manual Programming, Audit Collection,
Diagnostics, Rapid Advance, and Reset to Factory Defaults.
Break-In Alarm
This feature allows the owner to program the machine to signal a
network alarm, cause a machine alarm or shut down the machine
if the service door or coin vault is opened without disabling the
alarm first. The date and time of the break-in is recorded. To
avoid the alarm during coin collections, the alarm must be turned
off or temporarily disabled by pressing the two programmed
keys.
The alarm is turned off by default. The alarm can be turned on by
programming the control with an external device or network.
Special Vend
This feature allows the owner to program the control to allow
programmable vend prices for specific hours and dates.
For details on programming Special Vend, refer to
.
OPL Mode
This feature allows the user to start a cycle without satisfying the
vend price.
For details on enabling OPL Mode, refer to
.
Drop-Off Mode
This feature allows the owner to limit machine use to an attend-
ant without requiring vend. Starting the machine will require the
correct sequence of four keypad presses followed by the START
key as programmed by an external device. These keys can be pro-
grammed by an external device and are defaulted as modifier A,
modifier B, modifier C and NORMAL 90.
For details on enabling Drop-Off Mode, refer to
.
Low Power/Auto-Shutdown Option
This feature allows the owner to program the control to shut
down or enter a low power consumption mode based on program-
mable times and dates if either of these options are enabled.
For details on programming the Low Power/Auto-Shutdown op-
tion, refer to
Temperature Display
This feature allows the owner to view the water temperature on
the display of a machine with a heater by pressing any cycle key-
pad during an agitate or soak step of the cycle.
The temperature display is turned off by default. The feature can
be turned on by programming the control with an external device/
network or manually.
Out of Order Mode
This feature allows the owner to program Out of Order Mode
which can be used to show the user that the machine is not avail-
able to use. The control will accept coins and increment the ap-
propriate audit counters but the vend entered will not count to-
wards a cycle purchase, the coin audio will not work, and no cy-
cle will run while Out of Order Mode is active.
Network Node Number Display Mode
This feature allows the owner to program a command to be sent
from the IrDA or Network that requests the front-end control to
display the network node number. The Control will display
nXXX
where
XXX
is the network node number.
Error Display Mode
This feature is used to display a machine error. Only one error
will be displayed at the time if there are multiple errors. Once the
highest priority error is cleared, the next highest priority error
will be displayed if multiple errors exist. Refer to
for more details on errors, their displays, and their priorities.
Special Features
©
Published by permission of the copyright owner -
DO NOT COPY or TRANSMIT
19
Part No. 805405ENR5
Summary of Contents for BT3JGASG403UW01
Page 2: ......
