6. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Audio Signal
AUdio
This option allows the owner to program when the signal will
sound.
There are five occasions when a signal may sound during the
washer operation. These five occasions are listed below:
1.
End of Cycle Signal
By default, the signal is turned off. If
turned on, the signal will sound for three seconds at the end of
a cycle.
2.
Keypad Depression Signal
By default, this signal is turned
on and will sound for a quarter of a second. This signal will
sound each time a keypad is pressed.
3.
Coin Input/Card Insertion Signal
By default, this signal is
turned on and will sound for a quarter of a second each time a
coin or card is entered.
4.
Remove Card Signal (Card Models Only)
By default, this
signal is turned on and will sound one second on and one sec-
ond off when the control is prompting for card removal.
5.
Signal for Start
By default, this signal is turned on and will
sound one second on and one second off for 10 seconds after
vend price has been satisfied.
How to Program the Audio Signal
1. Control must be in Manual Mode. Refer to
2. Press the NORMAL 40 (
∧
) or the DELICATES COLD (
∨
)
keypad until
Prog
appears in the display. Press the START
(enter) keypad, and
AtS 1
will appear in the display.
3. Press the NORMAL 40 (
∧
) or the DELICATES COLD (
∨
)
keypad to scroll through the programmable options until
AU-
dio
appears in the display.
4. When
AUdio
appears in the display press the START (enter)
keypad. A number will appear in the display. This number
corresponds to the current Audio Signal Programming Value.
5. Locate the desired number in the first column of
the following page.
6. Press the NORMAL 40 (
∧
) or the DELICATES COLD (
∨
)
keypad to increase or decrease the current number until cor-
rect.
For Example: A user might wish to have the signal sound only
when a keypad is pressed. Entering the number “1” in step 5
would turn off all the options except KEYPAD. In this instance,
the signal would sound only when a keypad is pressed.
7. Press the START (enter) keypad when the correct number ap-
pears in the display. The next option will appear in the dis-
play.
How to Read Audio Signal Table
To determine the correct number required to program the Audio
Signal, use the following chart. The Signal Value column con-
tains the number required in step 6. The other columns corre-
spond to individual options.
Each column of options contains a unique combination of the
words “ON” and “OFF” that indicates if that column’s option is
turned on or off when the Signal Value is entered. Select the de-
sired combination of options and enter the number found in the
Signal Value column.
The default cycle programmed at the factory is 29.
Signal Value
Start Mode
Serial or Net-
work Vending
Command
Signal
Coin/Card In-
put
End of Cycle
Key Pressed
0
OFF
OFF
OFF
OFF
OFF
1
OFF
OFF
OFF
OFF
ON
2
OFF
OFF
OFF
ON
OFF
3
OFF
OFF
OFF
ON
ON
4
OFF
OFF
ON
OFF
OFF
5
OFF
OFF
ON
OFF
ON
6
OFF
OFF
ON
ON
OFF
Table 4
continues...
Programming Control
©
Published by permission of the copyright owner -
DO NOT COPY or TRANSMIT
49
Part No. 805405ENR5
Summary of Contents for BT3JGASG403UW01
Page 2: ......
