TORNADO WEBJET 128
Allied Data Technologies
20
Syntax
Value
Def.
Meaning
19 of 192 : 19200 bps
28 : 28800 bps
38 : 38400 bps
57 : 57600 bps
115 : 115200 bps
255 : select internal clock
(asynchronous clock information is derived from the S0 bus)
0 : select external clock
(asynchronous clock information originates from serial port)
S117
0..255
4
Timer of number of RING messages (seconds)
Time between two consecutive RING messages in incoming calls
0 : single RING message
S123
0..1
0
&D command
0 : use &D for DTR action
1 : ignore &D setting, force &D0
S124
0..255
1
Auto baud detection AT
0 : Auto baud off
1 : Autobaud on
E
0..1
1
Echo
E0
Echo off
E1
Echo on
Q
0..1
0
Result codes
Q0
Result codes on
Q1
Result codes off
V
0..1
1
Result code format
V0
Numeric
V1
Verbal
W
0..2
2
Speed indication in CONNECT
W0
CONNECT with serial port speed
No extended protocol messages when S95=0
W1
CONNECT with serial port speed
Also CARRIER and PROTOCOL messages when S95=0
W2
CONNECT with line speed
No extended protocol messages when S95=0
X
0..4
4
Dial and busy tone message and detection selection
X0
Busy tone and dial tone detection off, only CONNECT message
X1
Busy tone detection off, dial tone detection off CONNECT xxx message
X2
Busy tone detection off, dial tone detection on CONNECT xxx message
X3
Busy tone detection on, dial tone detection off CONNECT xxx message
X4
Busy tone detection on, dial tone detection on, CONNECT xxx message
&C
0..2
1
Carrier Detect signal (CD, 109) behavior
Synchronous mode: CD follows 'carrier'
status Asynchronous mode:
&C0
CD always on
&C1
CD follows 'carrier'
&C2
CD on when on-line, off when 'carrier' is gone, back on in rest
&D
0..3
2
Comportement DTR (108) (voir aussi S123)
&D0
&Q0, &Q5: DTR has no effect
&Q1: DTR going off: break connection
&Q2: DTR going off: break connection
DTR off and on: start dialing
&D1
&Q0, &Q1, &Q5: DTR going off: to command mode
&Q2: DTR going off: break connection
DTR off and on: start dialing