45-008 REV. 1/22
19
Maximum
Clearance
1/8"
Maximum
Clearance
1/32"
Maximum
Clearance
3/32"
Class III Shims Shown
Shim as Required
Bottom Bar
Bottom Hook
Bottom Hook
Spacer
Fork Base
Truck Mast
Lower ITA Bar
Roller
Assembly
Figure 4-6, Adjusting sideshifting lower bolt-on
hook assembly
WARNING
Equipment failure hazard.
The attachment could fall off the truck if the quick hook
is not properly installed.
Slide plate must click into place. If the slide plate does
not click into place because the truck carriage prevents
the slide plate from being raised up high enough, install
shims between the attachment and the body of the quick
hooks.
5. To ensure proper locking of the slide plate, use a screwdriver to try to pry down
the slide plate. If the slide plate is not locked in place, inspect and correct any
cause that might restrict the slide plate from going up enough to allow the button
to become fully engaged.
6. Apply grease to bronze top hooks through fittings and spread on entire slide area
of mid plate.
7. Check all fittings, connections and bolts for any interference.
4.3 Hydraulic Connections
1. Before connecting the truck hydraulic system to the attachment, the system
must
be purged through the filtration system. This will eliminate any contamination that
might exist in the auxiliary hydraulic system of the truck.
