50
A.
Lowering the equipment on the slope:
1.
Set the throttle on the tractor for the required engine
speed. Operator experience is required for this
operation so that the load is carefully controlled.
2. Keep the winch wire rope tightened between the
tractor and the equipment being lowered down the
slope. Use the control lever in the
LINE-OUT
position
to control the lowering of the equipment down the
slope.
3. Move the control lever between
LINE-OUT
and
BRAKE-ON
if inching is required. Use minimum
inching to prevent additional heat and wear.
B.
Raising the equipment on the slope:
1.
Set the throttle on the tractor for the required engine
speed. Operator experience is required for this
operation so that the load is carefully controlled.
2. Keep the winch wire rope tightened between the
tractor and the equipment being lowered down the
slope. Use the control lever in the
LINE-IN
position
to control the lowering of the equipment down the
slope.
3. Move the control lever between
LINE-IN
and
BRAKE-ON
if inching is required. Use minimal
inching to prevent additional heat and wear.
4.
Keep the equipment being raised in alignment with
the winch and tractor. Do not permit the winch wire
rope to loosen and pass under the drive wheels or
tracks of the tractor.
Summary of Contents for W12E
