32
INTERVAL
PROCEDURE OR QUANTITY
SPECIFICATION
50 hours or weekly.
Check oil level at plug (item 2). Add oil as
necessary through fi ll plug (item 5).
Do not
operate tractor when checking the oil level.
See Figure 3 – Recommended Oil List.
Check winch control lever (cable controls). See
Figure 16.
Use SAE 30 oil on the linkage if needed.
Check that the control cable and control
housing are fastened correctly. Tighten
U-bolts if required.
Check oil fi lter light, if continuously illuminated
with winch warm, replace the fi lter
Replace the fi lter.*
Clean the breather (item 6).
Remove debris around breather.
Lubricate the rollers on the fairlead assembly, if
the winch is so equipped.
Use multi-purpose grease with 2-4%
molybdenum disulfi de.
250 hours or monthly
There may be a gear box fastened to the front
of the winch which has a separate oil reservoir.
If this gear box lowers the Input shaft of the
winch, then the oil level in this gear box must
be checked and fi lled independently of the main
winch.
Fill to proper level if low. If oil level cannot
be checked, add 1/2 quart. See Figure
15-1 for details.
500 hours or every 3
months.
Clean the oil suction screen and magnets.*
Use a new gasket between the cover and
the suction tube.
Replace the fi lter.*
See the Parts Manual for fi lter element
and cover gasket. When replacing, be
sure to lubricate fi lter seal ring between
element and fi lter head.
Maintenance Schedule
(Continued on next page)
Summary of Contents for W8L
