Stacking Commands
©2008 Allied Telesis Inc. All rights reserved.
65.20
AlliedWare Plus
TM
Operating System Software Reference C613-50003-00 REV E
Software Version 5.2.1
stack management vlan
This command configures the virtual stack management VLAN ID. It can only be entered from
the stack master.
Syntax
stack management vlan <2-4094>
Default
VLAN ID 4094
Mode
Global Configuration Mode
Usage
This command is used only in the master and configures the VCS management VLAN ID.
The management VLAN is used for high speed communication between stacked units via the
XEM-STK or the two back panel stacking ports (SwitchBlade
®
x908 only). This command
enables you to change the ID of this VLAN.
The default stacking management VLAN ID is 4094, which is the last configurable VLAN ID in
the switch.
The VCS management VLAN is created and configured automatically so that the VCS VLAN
cannot be used in the stack's VLAN configuration commands (such as awplus(config-vlan)#
vlan <VCS management VLAN ID> bridge <1-23>).
The management VLAN should only be changed if the default VCS VLAN ID needs to be used
in the stack's VLAN configuration.
Warning
When the command is entered, the updated management VLAN configuration will take effect
once the stack is restarted.
If the management VLAN ID is changed by this command, you can use the
no stack
management vlan
command to change it back to default value.
Examples
To set the management VLAN to 4000:
Related Commands
stack management subnet
Parameter
Description
stack
Virtual Chassis Stacking (VCS)
management
VCS management VLAN configuration
vlan
VCS management VLAN
<2-4094>
VCS management VLAN ID. Default: 4094.
no
Sets the stack management VLAN command back to its default value of
4094.
awplus#
configure terminal
awplus(config)#
stack management vlan 4000