OSPF Configuration
©2008 Allied Telesis Inc. All rights reserved.
29.10
AlliedWare Plus
TM
Operating System Software Reference C613-50003-00 REV E
Software Version 5.2.1
Switch 3
Switch 4
Names of Commands Used
network area, ip ospf cost
Validation Commands
show ip ospf route 10.10.14.0/24
awplus(config)#
interface vlan3
Specify the interface (
vlan3)
to be configured.
awplus(config-if)#
ip ospf cost 150
Set the OSPF cost of this link to
100
.
awplus(config-if)#
exit
Exit the
Interface
mode and return to
Configure
mode.
awplus(config)#
router ospf 100
Configure the Routing process and specify the Process ID
(
100
). The Process ID should be a unique positive integer
identifying the routing process.
awplus(config-router)#
network 10.10.12.0/
24 area 0
awplus(config-router)#
network 10.10.13.0/
24 area 0
Define interfaces on which OSPF runs and associate the
area ID
(0)
with the interface.
awplus(config)#
router ospf 100
Configure the Routing process and specify the Process ID
(
100
). The Process ID should be a unique positive integer
identifying the routing process.
awplus(config-router)#
network 10.10.11.0/
24 area 0
awplus(config-router)#
network 10.10.13.0/
24 area 0
awplus(config-router)#
network 10.10.14.0/
24 area 0
Define interfaces on which OSPF runs and associate the
area ID
(0)
with the interface.