BGP Commands
©2008 Allied Telesis Inc. All rights reserved.
31.84
AlliedWare Plus
TM
Operating System Software Reference C613-50003-00 REV E
Software Version 5.2.1
neighbor strict-capability-match
Use this command to close the BGP connection if capability value does not completely match
to remote peer.
Use the
no
parameter with this command to disable this function
Syntax
neighbor
<
neighborid
>
strict-capability-match
no neighbor
<
neighborid
>
strict-capability-match
Mode
Router mode
Examples
Parameter
Description
<
neighborid
>
{
A.B.C.D
|
TAG
}
A.B.C.D
Specifies the address of the BGP neighbor in IPv4 format.
TAG
Name of an existing peer-group. For information on how to
create peer groups, refer to the
neighbor peer-group (adding
a neighbor) command on page 31.71
,
and
neighbor remote-
as command on page 31.75
. When this parameter is used
with a command, the command applies on all peers in the
specified group.
awplus#
configure terminal
awplus(config)#
router bgp 12
awplus(config-router)#
neighbor 10.10.10.10 strict-capability-
match