C613-22132-00 REV A
SIM card detection test
|
Page
42
5G Mobile Broadband UTM Firewall
Step 9:
Disable SIM 1
Use the command
no sim enable
to disable SIM 1. SIM 2 automatically becomes the active SIM.
awplus(config)#
no sim enable sim1
awplus(config)#
end
Step 10:
Display the SIM status
Use the command
show 5g sim
. Observe that the administrative state for slot 1 is down and is
invalid, while slot 2 is up and is the backup:
awplus#
show 5g sim
SIM Status:
Slot 1 is : Present
Slot 1 administrative state : Down
Slot 1 present, up and configured : Yes
Slot 1 is : Invalid
Slot 1 APN : carrier1
Slot 1 APN name : carrier_name.co.nz
Slot 1 User name : Not Set
Slot 1 Password : Not Set
Slot 1 Authentication type : Not Set
Slot 1 Packet data protocol type : ipv4-or-ipv6
Slot 2 is : Present
Slot 2 administrative state : Up
Slot 2 present, up and configured : Yes
Slot 2 is : Backup
Slot 2 APN : carrier1
Slot 2 APN name : carrier_name.co.nz
Slot 2 User name : Not Set
Slot 2 Password : Not Set
Slot 2 Authentication type : Not Set
Slot 2 Packet data protocol type : ipv4-or-ipv6
SIM Failover Interval : 300 seconds
Network is running : True
