Chapter 8: Cabling the Networking Ports
100
Cabling Twisted Pair Ports
Here are the guidelines to cabling the twisted pair ports on the switches:
The minimum twisted pair cable requirements are as follows:
– 10/100 Mbps ports: Standard TIA/EIA 568-B-compliant
Category 3 unshielded cabling.
– 1/2.5/5 Gbps ports: Standard TIA/EIA 568-A-compliant
Category 5 or TIA/EIA 568-B-compliant Enhanced Category 5
(Cat 5e) unshielded cabling.
– 10 Gbps ports: Standard TIA/EIA 568-C-compliant Category 6a
unshielded cabling.
PoE is enabled by default on the AT
-
x530
-
28GPXm and AT-x530-
52GPXm switch ports.
The connectors on the cables must fit snugly into the ports, and the
tabs must lock the connectors into place.
The default speed setting for the ports is Auto-Negotiation. This
setting is appropriate for ports connected to network devices that
also support Auto-Negotiation.
The ports must be set to the default setting of Auto-Negotiation to
operate at 1000 Mbps and higher.
The ports support full-duplex only when operating at 1 Gbps and
higher. The ports support half- and full-duplex when operating at
10/100 Mbps.
Do not attach cables to ports of static or Link Aggregation Control
Protocol (LACP) port trunks until after you configure the trunks on
the switch. Otherwise, the ports will form network loops that can
adversely affect network performance.
Summary of Contents for AlliedWare Plus AT-x530 Series
Page 10: ...Tables 10...
Page 14: ...Preface 14...
Page 58: ...Chapter 3 Installing the Switch on a Table 58...
Page 90: ...Chapter 6 Powering On the Switch 90...
