x530 Series Installation Guide for Stand-alone Switches
97
Saving Your Changes and Rebooting the Switch
After disabling the VCStack feature, save your configuration changes and
reboot the switch. Changes to the status of the VCStack feature do not
take affect until after you reboot the unit.
To save your configuration changes and reboot the switch, perform the
following procedure:
1. To return to the Privileged Exec mode, from the Global Configuration
mode, type the command EXIT.
Figure 46. Returning to the Privileged Exec Mode
2. To save your change in the configuration file, type the command
WRITE.
Figure 47. Saving the Changes with the WRITE Command
If this is the initial management session, the switch automatically
creates the Default.cfg configuration file and stores the change in the
file.
3. To reboot the switch, type the command REBOOT.
4. To confirm, type “Y” for yes.
5. Wait two minutes for the switch to initialize the management software
and then examine the Switch ID LED again. The switch is ready for
normal network operation as a stand-alone unit if its ID number is “0.” If
the number is not “0,” repeat the procedures in this chapter, being sure
to save your configuration changes with the WRITE command.
6. Go to Chapter 8, “Cabling the Networking Ports” on page 99.
awplus(config)# exit
awplus#
awplus# write
Building configuration ...
[OK]
awplus#
Summary of Contents for AlliedWare Plus AT-x530 Series
Page 10: ...Tables 10...
Page 14: ...Preface 14...
Page 58: ...Chapter 3 Installing the Switch on a Table 58...
Page 90: ...Chapter 6 Powering On the Switch 90...
