Chapter 3: Installing the Router and Powering on the Router
28
Connecting AC Power to a Power Supply Module
The router has a single fan which pulls air into the chassis through the
intake air vents to cool the chassis components. The air is discharged
through the exhaust air vents on the top of the chassis front panel. See
Figure 1 on page 15 and Figure 2 on page 15 for the location of the
exhaust vents. See Figure 3 on page 16 for the location of the intake air
vents.
Warning
On both the AT-AR3050S and AT-AR4040S routers, keep the intake
vents clear of any obstructions to insure proper cooling of the router
components.
To power on the routers, perform the following procedure:
1. Position the power cord retaining clip in the up position, as shown in
Figure 13. Power cord retaining clip in the up position
2. Plug the power cord into the AC power connector on the rear panel of
the unit. Lower the power cord retaining clip to secure the power cord
to the unit.
F
F
O
O
I
N
O
AC INPUT
100-240V
50/60Hz
0.9A
Summary of Contents for AT-AR3050S
