AT-SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
155
Start a new management
session on the switch. For
instructions, refer to “Starting a
Local Management Session” on
page 145.
awplus> enable
awplus#
Enter the ENABLE command to
move from the User Exec mode
to the Privileged Exec mode.
awplus# show stack detail
.
.
.
Stack port1.2.1 status
Down
Stack port1.5.4 status
Down
Enter the SHOW STACK
DETAIL command to confirm
that the designated ports are
now trunk ports. (The status of
the ports should be Down at this
point because the ports are not
cabled yet.)
Go to “Powering Off the Switch”
on page 156.
Table 14. Example of Designating Trunk Ports (Continued)
Command
Description
Summary of Contents for AT-FAN08
