TurboStack Chassis and Backplanes
13
3. Place the left rear corner of the chassis edge first in the stand (Figure 10).
Figure 10: Vertical Mount Installation
4. Plug in the power cord to turn on the fan.
You are done with the vertical installation. Follow the procedures to install
hubs and other single-height modules in the chassis.
Installing Hubs and Other Modules in the Chassis
Warning
Improper installation may expose the module to debris and block vents,
causing damage due to insufficient cooling. See Electrical Safety and
Installation Requirements on page i.
If you have a rackmount installation, make sure you have installed the chassis
in the 19-inch relay rack (page 12).
To install hubs and other modules in the chassis:
1. Plan the network configuration and identify the modules you want to use
in the chassis.
2. Remove the faceplates/air-dams from the chassis slots where you are
installing modules.
Save the faceplates. You need to re-install them to cover empty slots at a
later date. You may discard the faceplate screws and nuts.
3. Identify the master hub module.
You will install this master module in slot 1 (Step 7 of this procedure).
Stand for vertical mount
