Chassis Installation
12
To install the rackmount chassis in a 19-inch rack:
1. Support the chassis and slide it into a rack.
2. Attach the chassis frame to the rack via the four corner holes using the
rackmount screws provided.
3. Plug in the power cord to turn on the fan.
You are done with the rackmount installation. Proceed to page 13 for the
procedures to install hubs and other single-height modules in the chassis.
To install the desktop chassis horizontally:
1. Attach the four self-adhesive rubber feet to the bottom of the desktop
chassis about 6 mm (0.25 in.) from each corner.
Figure 9: Attaching the Self-Adhesive Rubber Feet
2. Plug in the power cord to turn on the fan.
You are done with the horizontal installation. Proceed to page 13 for the
procedures to install hubs and other single-height modules in the chassis.
To mount the 4-slot desktop chassis vertically:
The following steps refer to the 4-slot desktop chassis only:
1. Remove the self-adhesive rubber feet from the bottom of the chassis, if in
place.
2. Place the chassis on its left side with the fan towards the top.
6 mm (0.25 in.)
Typ.
