Chapter 7: Virtual Access Points
111
Figure 36. None Selection in the VAP Security Tab
6. Click the
SAVE & APPLY
button to save and update the configuration,
or configure other VAPs and save the configurations at once later.
Static WEP
To configure a VAP for Static WEP security, perform the following
procedure:
Note
Static WEP is only supported when the radio mode is set to
IEEE802.11b/g or IEEE802.11/a. See “Configuring Basic Radio
1. Select
Settings
>
VAP / Security
from the main menu.
2. Select
Radio1
or
Radio2
from the sub-menu. The default is Radio1.
You can configure only one radio at a time.
3. Select a VAP to configure from the next sub-menu. The default is
VAP0.
Note
You can configure multiple VAPs without saving each VAP
configuration page. You can save multiple VAP configurations all at
once by clicking the
SAVE & APPLY
button.
4. Select the
Security
tab.
5. Select
Static WEP
from the Mode pull-down menu. See Figure 37 on
Summary of Contents for TQ6000 GEN2
