Chapter 3: System Settings
45
4. Configure the fields by referring to Table 7.
Table 7. Network DHCP Window
Parameter
Description
Hostname
Enter a hostname for the access point. Here
are the guidelines:
- The hostname can be from 1 to 63
alphanumeric characters.
- The hostname cannot contain spaces or any
special characters, except hyphens.
- The first or last character cannot be a
hyphen.
- The access point can have only one
hostname.
- The default is one of the following,
depending upon the model of your access
point:
• AT-TQ6702 GEN2
• AT-TQm6702 GEN2
• AT-TQ6602 GEN2
• AT-TQm6602 GEN2
- If you want the DHCP server to supply the
hostname, enable the Get Hostname from
DHCP Server option in this window.
Connection Type
Select
DHCP
. This is the default. The Static IP
selection is explained in “Assigning a Static
IPv4 Address to the Access Point” on page 47.
Get Hostname
from DHCP
Select one of the following options:
- Enabled: When the DHCP server assigns an
IP address to the access point, the server
assigns a host name as well.
- Disabled: The DHCP server does not change
the hostname of the access point. This is the
default setting.
DNS Nameserver
Enter the IP address of the DNS server. If this
field is left blank, the access point tries to
obtain the address from the DHCP server. The
default is no name.
Summary of Contents for TQ6000 GEN2
