Chapter 3: System Settings
59
Read-Only
Community Name
(SNMPv1 and
SNMPv2c only)
Specifies the community name.
Port
Specify the port number for SNMP. The range
is 1 to 65535. The default is 161.
Restrict the Source
of SNMP Requests
(SNMPv1 and
SNMPv2c only)
Restricts the use of SNMP to specific subnets
or individual workstations.
The options are:
- Enabled: Restrict the use of SNMP on the
access point to only the management
stations specified in the Only allow from the
designated hosts or subnets field.
- Disabled: Permit any workstation to use the
community string to view the device. This is
the default setting.
Username
(SNMPv3 only)
Specify a user name for SNMP.
Password
(SNMPv3 only)
Specify a password for SNMP.
Table 12. SNMP Window (Continued)
Field
Description
Summary of Contents for TQ6000 GEN2
