Chapter 3: System Settings
67
Enabling or Disabling the Reset Button
This section explains how to enable or disable the Reset button on the rear
panel of the access point. You use the Reset button to restore the default
settings to the device.
If the unit is installed in a non-secure area, you might disable the button to
prevent unauthorized individuals from pressing it and disrupting the
operations of your wireless network.
Note
If you disable the Reset button, be sure not to forget the manager
account password. Otherwise, you will not be able to manage the
unit with the web browser interface.
To enable or disable the Reset button, perform the following procedure:
1. Select
Settings
>
System
from the main menu.
2. Select
Hardware
from the sub-menu. Refer to Figure 20.
Figure 20. Hardware Window
3. From the
ResetButton Enable
pull-down menu, select one of the
following:
Enabled: The Reset button is enabled. This is the default setting.
Disabled: The Reset button is disabled.
4. Click the
SAVE & APPLY
button to save and update the configuration.
Summary of Contents for TQ6000 GEN2
