TQ6000 GEN2 Access Poinst User’s Guide
80
Mode
(Radio2)
Select the communications protocol for Radio2 from
the pull-down menu. The selections are listed here:
- IEEE 802.11a: The access point accepts 802.11a
clients.
- IEEE 802.11a/n/ac/ax: The access point accepts
802.11a, 802.11n, 802.1acn,and 802.11ax clients.
This is the default for Radio2.
Wi-Fi multimedia (WMM) has to be enabled (default)
to use IEEE 802.11n, IEEE 802.11ac, or
IEEE 802.11ax. Refer to “Configuring QoS Basic
Channel
Select the channel for the radio from the pull-down
menu. Here are the guidelines:
- You can select only one channel.
- The channels vary by radio, bandwidth, and
country.
- To view the current active channel, refer to
“Displaying Radio Status” on page 87.
Bandwidth
(Radio1)
Select the bandwidth for Radio1 from the pull-down
menu. The selections for IEEE 802.11n are listed
here:
- 20 MHz. This is the default setting.
- 40 MHz
For IEEE 802.11n modes, channel width can be 40
MHz-wide or the legacy 20 MHz-wide. The 40
MHz-wide channel allows for higher data rates, but
reduces the number of available channels for other
wireless devices.
The only bandwidth for IEEE 802.11b/g is 20 MHz.
Table 16. Basic Radio Settings Window (Continued)
Field
Description
Summary of Contents for TQ6000 GEN2
