Installation
8
Environment
Your AT-TS90TR will operate from 0 to 40 degrees C with a relative
humidity from 5% to 80% non-condensing.
You should allow at least 191 mm (7.5 inches) between an obstruction and
both sides and rear panel of the TurboStack chassis or the AT-TS90TR
when mounted as a stand-alone unit to allow adequate cooling air flow.
Power
Your AT-TS90TR has autoranging power supplies which let it operate
normally with input voltage of:
100 to 120 VAC, 5/60Hz, 1.5 A or
200 to 240 VAC, 50/60 Hz, 0.75 A
The rated power consumption of your AT-TS90TR is 82 watts.
Quick Install
The Quick Install instructions take you through mounting your AT-
TS90TR and connecting it to a network.
Mounting in a
TurboStack Chassis
Your AT-TS90TR is shipped with all brackets, screws and other hardware
items necessary to install the unit in a TurboStack chassis. Mount the
unit in the bottom slot of ATI’s 36RG7/C36DG7 chassis using the following
procedure:
It is not necessary to power-down other units already mounted in the
TurboStack chassis during the installation process. Your TurboStack units
are all designed to be hot-swappable to minimize network down-time.
1.
Remove the air dam from the bottom position of the TurboStack
chassis.
2.
If the rubber feet are installed (factory default) on the bottom of the AT-
TS90TR, remove them.
3.
Insert the AC power cord connected to an AC power source into the
Power connector on the front panel, powering the unit. Make certain all
other modules in the TurboStack Chassis also have power applied.
4.
Engage the side rails on each side of the AT-TS90TR with their
corresponding slots on the TurboStack chassis.
5.
Gently push the AT-TS90TR into the chassis until you feel the rear
connector engage with the connector on the motherboard. Continue
pressing the AT-TS90TR into the TurboStack chassis until it is
completely seated.
6.
Lift the handles on each side of the unit and secure the AT-TS90TR to
the TurboStack chassis with the mounting screws provided.
7.
Press the handles down so they are flush with the front panel.
Installation of the AT-TS90TR hardware in the TurboStack Chassis is now
complete.
!
Caution
Note
