Installing the hardware
173
Alvium CSI-2 Cameras User Guide V2.6.2
Schematic drawings in
show the Alvium CSI-2 bare board camera. Only
the mounting area (gray) can be used for mounting. The sensor and electronics
area (red) must not be touched nor put at mechanical stress.
a = Mounting hole | b = Mounting hole and chassis ground
Mount the bare board with four M2 screws at 0.1 Nm maximum torque.
Mounting open housing cameras
Bottom or top mounting
The maximum torque value applies only if the entire thread engagement is
used.
For other values, see
Adapting maximum torque values
1. Mount the camera to the base using suitable M3 screws at 0.51 Nm maximum
torque for a thread engagement (C) of 2.2 mm between screws and mounting
threads, see
. For technical drawings, see
Figure 68: Mounting area of Alvium CSI-2 bare board cameras
connector side (left); sensor side (right)
Figure 69: Top and bottom and mounting threads (c)
b
a
a
a
b
a
a
a
Top
Detail c:
DϯљϮ͘Ϯљϰ͘Ϭ
сDϯͮсϬ͘ϯͮсϮ͘Ϯͮсϰ͘Ϭ
ϮϬŵŵ
c
c
D
B
C
A