48
Alvium USB Cameras User Guide V3.6.4
Specifications
Cameras were inspected before and after the tests. All tests were passed
successfully:
The conditions for cameras and lenses were the same for all tests. Solid aluminum
tubes were used to represent real lenses:
IEC 60068-2-6: Sinusoidal vibration
Condition
Passed
Mechanics
• The camera housings showed no deformations.
• The connections between camera components had not come loose.
• The sensor position was within the specified tolerances of a new camera.
Camera behavior
Camera functionalities were not affected, no deviations occurred.
Image streaming
Images were streamed without errors.
Table 7: Conditions for passed tests
Parameter
Value
Lens dummy length
38 mm
Lens dummy mass
70 g
Center of gravity (CoG)
1
20 mm
1
For camera and lens dummy assemblies, measured from the lens mount front flange
Table 8: Conditions for lenses
Frequency
Acceleration
Displacement
10 Hz to 58.1 Hz
Not applicable
1.5 mm
58.1 Hz to 500 Hz
20
g
Not applicable
Table 9: Frequency, acceleration, and displacement for IEC 60068-6 tests
Parameter
Value
Axis
x, y, z
Sweep rate
1 oct/min
Sweep duration per axis [hh:mm:ss] 00:11:17
Number of sweeps
20
Table 10: Other parameters for IEC 60068-6 tests
