Preparing Cameras without
Sensor Cover Glass
Page 15 of 18
9.4. Reassembling Prosilica GT Extended Format housing cameras
1. Position sensor unit and lens mount, so that markers (c) align.
2. Keeping screws (a) and spacers in place, fit the sensor unit (b) as a unit into the lens mount (d)
3. Tighten the two M2 x 16 socket head cap screws (e) at a maximum torque of 4 lbf-in (0.45 Nm).
4. Position front assembly and body assembly, so that markers (g) align.
5. Mount the front assembly (f) to the body assembly (h).
6. Insert and tighten the four M2 x 8 socket head cap screws at a maximum torque of 4.5 lbf-in (0.51 Nm).
Figure 24: Fitting the sensor unit into the lens mount
Figure 25: Tightening the two M2 x 16 socket head cap screws
Figure 26: Mounting the front assembly to the body assembly
Figure 27: Inserting and tightening the four M2 x 8 socket head cap screws of the front assembly
b
a
d
c
e
e
f
g
h
