Camera interfaces
185
Prosilica GT Technical Manual V3.2.0
Camera I/O connections
The GPIO port uses a Hirose HR10-10R-12PA(73) connector on the camera side.
The mating cable connector is Hirose HR10A-10P-12S.
I/O connector pin assignment
Safety-related instructions to avoid malfunctions
Read all Notes and Cautions in the Hardware and Installation
chapter before using
the Hirose I/O connector.
Hirose connector
The cable side Hirose 12-pin female connector is available for purchase from Allied
Vision (order code: K7600040).
Camera side Hirose HR10A-10R-12PB connector
I/O cable
color code
Pin
Signal
Direction
Level
Description
1
Camera GND
In
GND for RS232 and
external power
Ground for camera
power supply and RS232
Blue
2
Camera Power
In
7 to 25 VDC
Camera power supply
Red
3
Out 4
Out
Open emitter
Nominal 5 mA;
Maximum 8 mA
Opto-isolated Output 4
(SyncOut4)
Pink
4
In 1
In
LVTTL
maximum 3.3 V
Non-isolated Input 1
(SyncIn1)
Gray
Table 88: Camera I/O connector pin assignment and color coding (sheet 1 of 2)
1
9
8
7
6
5
4
3
2
11 12
10
