Guppy PRO Technical Manual
V4.1.2
121
To change the color-correction coefficients in
SmartView
, go to
Adv3
tab.
Switch color correction on/off
Color correction can also be switched off in YUV mode:
Note
•
A number of 1000 equals a color correction coefficient of
1.
•
To obtain an identity matrix set values of 1000 for the
diagonal elements an 0 for all others. As a result you get
colors like in the RAW modes.
•
The sums of all rows should be equal to each other. If
not, you get tinted images.
•
Color correction values range -1000 to +2000 and are
signed 32 bit.
•
In order for white balance to work properly ensure that
the row sum equals 1000.
•
Each row should sum up to 1000. If not, images are less
or more colorful.
•
The maximum row sum is limited to 2000.
Note
Configuration
To configure the color-correction coefficients in an advanced
register, see
.
Note
Configuration
To configure this feature in an advanced register, see
.
Note
Color correction is deactivated in RAW mode.
