Guppy PRO Technical Manual
V4.1.2
139
If there is no trigger impulse after the camera has been armed, one-shot can
be canceled by clearing the bit.
One-shot command on the bus to start of exposure
The following sections describe the time response of the camera using a single
frame (one-shot) command. As set out in the IIDC specification, this is a
software command that causes the camera to record and transmit a single
frame.
The following values apply only when the camera is idle and ready for use. Full
resolution must also be set.
Figure 68: One-shot control (SmartView)
#
Read = rd
Write = wr
Address
Value
Description
7
wr
F0F0061C
80000000
Do one-shot.
6
rd
F0F0061C
00000000
Read out one-shot register.
5
wr
F0F00830
82000000
Switch on external trigger mode 0.
4
rd
F0F00830
80000000
Check trigger status.
3
wr
F0F00614
00000000
Stop free-run.
2
rd
F0F00614
80000000
Check Iso_Enable mode (
free-run).
1
rd
F0F00614
00000000
This line is produced by SmartView.
Table 68: One-shot control: Descriptions