Guppy PRO Technical Manual
V4.1.2
241
The user can specify which user profile will be loaded upon startup of the
camera.
This frees the user software from having to restore camera settings, that differ
from default, after every startup. This can be especially helpful if third-party
software is used which may not give easy access to certain advanced features
or may not provide efficient commands for quick writing of data blocks into the
camera.
Standard registers
Standard registers
(Format_7)
Advanced registers
Cur_V_Frm_Rate
Cur_V_Mode
Cur_V_Format
ISO_Channel
ISO_Speed
BRIGHTNESS
AUTO_EXPOSURE (Target gray level)
WHITE_BALANCE (+ auto on/off)
HUE (+ hue on)
SATURATION (+ saturation on)
GAMMA (+ gamma on)
SHUTTER (+ auto on/off)
GAIN
TRIGGER_MODE
TRIGGER_POLARITY
TRIGGER_DELAY
ABS_GAIN
IMAGE_POSITION (AOI)
IMAGE_SIZE (AOI)
COLOR_CODING_ID
BYTES_PER_PACKET
TIMEBASE
EXTD_SHUTTER
IO_INP_CTRL
IO_OUTP_CTRL
IO_INTENA_DELAY
AUTOSHUTTER_CTRL
AUTOSHUTTER_LO
AUTOSHUTTER_HI
AUTOGAIN_CTRL
AUTOFNC_AOI (+ on/off)
TRIGGER_DELAY
MIRROR_IMAGE
LUT_CTRL (LutNo; ON_OFF is not saved)
Table 148: User profile: stored settings
Note
•
A profile save operation automatically disables capturing
of images.
•
A profile save or restore operation is an uninterruptable
(atomic) operation. The write response (of the
asynchronous write cycle) will be sent after completion
of the operation.
•
Restoring a profile will not overwrite other settings than
listed above.
•
If a restore operation fails or the specified profile does
not exist, all registers will be overwritten with the hard-
coded factory defaults (profile #0).
•
Data written to this register will not be reflected in the
standard memory channel registers.
