Guppy PRO Technical Manual
V4.1.2
99
write step because the size of an LUT is larger than GPDATA_BUFFER.
Therefore, input must be handled in several steps. The flow diagram below
shows the sequence required to load data into the camera.
Figure 39: Loading an LUT
Note
Configuration
•
To configure this feature in an advanced register, see
.
•
For information on GPDATA_BUFFER, see
Query limits from
register:
LUT_INFO and
GPDATA_INFO
Set EnableMemWR
to true (1)
Set AddrOffset to 0
Write n databytes
in
GPDATA_BUFFER
Offset is increased
in camera after n
bytes are written
Check
EnableMemWR for
no change
Repeat steps until
all data is written
Set EnableMemWR
to false (0)
