Mako Technical Manual
V3.0.0
17
Specifications
On-board FIFO
64 MByte, up to 99 frames at full resolution, Mono8/Bayer8, and a
GevSCPSPacketSize
= 8192 bytes per packet
Mono formats
Mono8, Mono12Packed, Mono12
Color formats
BayerRG8, BayerRG12Packed, BayerRG12, Mono8, RGB8Packed,
BGR8Packed, YUV411Packed, YUV422Packed, YUV444Packed
Exposure control
83 μs to 2.0 s; 1 μs increments
Gain control
0–26
dB
Binning
N/A
Decimation
Horizontal and Vertical: 1, 2, 4 factor
Opto-coupled I/Os
1 input, 3 outputs
Voltage requirements
12–24 VDC or PoE
Power consumption
2.1 W @ 12 VDC, 2.3 W PoE
Trigger latency*
Idle state: 3.1 μs
Frame valid state: 3.1 μs
Trigger jitter*
Idle state: 1.2 μs
Frame valid state: 3.1 μs
Operating temperature
+5°C to +45°C (housing temperature)
Storage temperature
-10°C to +70°C ambient temperature (without condensation)
Body dimensions (L x W x H)
60.5 x 29 x 29 mm; including connectors, without tripod and lens
Mass
80 g (without lens)
Hardware interface standard
PoE, IEEE 802.3af 1000BASE-T, 100BASE-TX
Software interface standard
GigE Vision Standard 1.2
Camera control interface
GenICam V1.0 compliant
Regulatory
CE, FCC Class B, RoHS (2011/65/EU), WEEE
*These values are calculated directly from the microcontroller source. These values are only valid for
pixel formats < 16 bit per pixel and applicable in both Idle and Frame valid state:
– Idle state: sensor is ready and camera is idle, waiting for the next trigger
– Frame valid state: sensor is reading out and camera is busy. If the next frame is requested by an
external trigger in this state, higher latency may occur as compared to the Idle state
Feature
Specification
Table 3: Mako G-030B/C camera specifications
