Specifications
33
Mako G Technical Manual V4.2.2
Decimation
Horizontal and Vertical: 1, 2, 4, 8 factor
Opto-isolated I/Os
1 input, 3 outputs
Voltage requirements
12 to 24 VDC; PoE
Power consumption
2.0 W @ 12 VDC; 2.2 W PoE
Trigger latency
3
Idle state: 32.6 µs; Frame valid state: 32.6 µs
Trigger jitter
3
Idle state: 8.1 µs; Frame valid state: 8.1 µs
Operating temperature
+5°C to +45°C housing temperature
Storage temperature
-10°C to +70°C ambient temperature (without condensation)
Body dimensions (L x W x H)
60.5 x 29 x 29 mm
Mass (typical)
80 g
Interface
IEEE 802.3 1000BASE-T (Gigabit Ethernet), IEEE 802.3af (PoE)
Interface standard
GigE Vision Standard V1.2
Camera control standard
GenICam SFNC V1.2.1
Regulations
CE, RoHS, REACH, WEEE, FCC, ICES
Temperature monitoring
Available for main board only.
Resolution: 0.031; Accuracy: ± 1 °C
1
For more information on available optical filters see the
2
The Mako G-131B, G-131C supports
BinningHorizontalMode
=
Sum
or
Average
and
BinningVerticalMode
=
Sum
or
Average
.
3
These values are calculated directly from the microcontroller source. These values are only valid for pixel formats
< 16 bits per pixel and applicable in both Idle and Frame valid states:
•
Idle state: sensor is ready and camera is idle, waiting for the next trigger.
•
Frame valid state: sensor is reading out and camera is busy. If next frame is requested by an external trigger in
this state, higher latency may occur as compared to the Idle state.
•
The e2v sensor does not support exposure duration via external level trigger.
Overlapping exposure and readout
The e2v sensor does not support overlapped exposure and readout in hardware
trigger mode or in global reset mode.
Feature
Specification
Mako G-131B
Mako G-131C
Table 8: Mako G-131B, G-131C model specifications (continued)
