Camera interfaces
81
Mako G Technical Manual V4.2.2
Gigabit Ethernet interface
The Gigabit Ethernet interface conforms to the IEEE 802.3 1000BASE-T standard
for Gigabit Ethernet over copper. To prevent electromagnetic interference (EMI)
and for best performance, Category 6 (or higher) cables with S/STP shielding and
connectors are recommended. Applications with longer cable lengths or harsh EMI
conditions require Category 7 (or higher) cables.
Camera I/O connector pin assignment
The general purpose I/O port uses a Hirose HR25-7TR-8PA(73) connector on the
camera side. The mating cable connector is Hirose HR25-7TP-8S.
•
Cable lengths up to 100 m are supported.
•
The 8-pin RJ-45 jack provides a pin assignment according to the Ethernet
standard, IEEE 802.3 1000BASE-T.
•
All Mako G cameras are PoE capable (IEEE 802.3af-2003).
•
If both the Hirose I/O port and Gigabit Ethernet interface (via PoE) are used for
power, the camera will only use the power from the Hirose I/O port.
Accessories
Please contact Allied Vision sales representative or your Allied Vision distribution
partner for information on accessories offered by Allied Vision:
https://www.alliedvision.com/en/about-us/where-we-are.html
Safety-related instructions to avoid malfunctions
Read all
Notes and Cautions
in the
GigE Installation Manual
before using the Hirose
I/O connector.
Hirose connector
The cable side Hirose connector is available for purchase from Allied Vision (order
code K7600503).
i
2
5
4
7
1
3
6
8
