Comfort Sync™ 7-Day Programmable Communicating Thermostat
Page 21
2. Select an access point that has already been established and
connected. There are two options to select from:
connect
and
AP info
.
Select
AP info
and verify the RSSI strength. If the signal is between
-1 and -69, then the signal strength is sufficient. If the signal strength
is outside of this range, install the router closer to the thermostat or add
a repeater.
ACCESS POINT INFO
Detailed information for the access point
MAC=
WSTATE = CONN
BSSID = 68
RSSI = -46
IP addr =
Figure 34. Verifying Signal Strength
NOTE -
Remember that walls, appliances, equipment and other barriers will
reduce signal strength.
Rebooting the Thermostat to To Establish
Connection to the Server
If, after successfully connecting the thermostat to your wireless router, the
following message appears on the screen:
Connection to server has not been established or it has been
lost. Please wait until the connection is established,
wait five minutes. Perform the following procedure, if the server connection
is still not established.
1. From the Home screen, touch the Allied logo (bottom right-hand corner
of screen) and
hold
for 5 seconds (see figure 35).
indoor temperature
indoor humidity is 41%
fan is
OFF
9:39 am May 23, 2013
fan is
AUTO
cool-to
set temp
75
Heat-to
72
heat
or
cool
fan is
AUTO
enter
away
outdoor
temperature
80
system is cooling
Wi-Fi
?
Figure 35. Rebooting the Thermostat
2. A message screen stating “Qualified Allied equipment installer
warning” screen appears (figure 36).
WARNING!
The following screens are intended for use by qualified
equipment installers only.
yes
no
reset
Do you want to proceed?
Figure 36. Qualified Equipment Installer Warning
