8.2 Removal
~
WARNING
~
Always wear gloves and eye protection
when disconnecting hydraulic con-
nections, and removing mounting pins
and hardware.
~
CAUTION
~
Do not disconnect hydraulics if hoses
are pressurized.
~
WARNING
~
Hoses, hydraulic motor and hydraulic
fittings may be hot after operation.
~
WARNING
~
Keep hands and fingers clear of
mounting pin holes, carrier linkage and
other pinch points while equipment is
positioned.
~CAUTION~
During removal, instruct carrier operator
to operate carrier controls only as
instructed by Ho-Pac installer.
1. Position Ho-Pac safely on the ground.
2. Remove hydraulic connections.
3. Be sure unit is stable prior to
removing mounting hardware.
4. Remove mounting hardware.
5. Reinstall mounting hardware on Ho-
Pac to avoid loss or damage.
7/21/03
20
Summary of Contents for Ho-Pac NT8900 Series
