29
Check the box <Continue image upload> to upload the triggered images
during certain time or keep uploading until the trigger is off. Select
<Upload for __sec> and enter the duration in the blank. The images of
the duration will be uploaded to FTP when the motion event occurs. The
setting range is from 1 to 9999 seconds. Select <Upload during the
trigger active> to make the images keep being uploaded to FTP during
the trigger active until the event stops. Set the Image frequency as the
upload frame rate. The setting range is from 1 frame to 15 frames.
NOTE:
Make sure FTP configuration has bee n completed. Refer
to
FTP
for further details.
Upload Image by E-Mail
Select this item and the Administrator can assign an e-mail address and
configure various parameters. When motion is detected, event images
will be sent to the appointed e-mail address.
<Pre-trigger buffer> function allows users to check what happened to
cause the trigger. The <Pre-trigger buffer> frame rate could be
pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain
amount of images after the motion event occurs.
Check the box <Continue image upload> to upload the triggered images
during certain time or keep uploading until the trigger is off. Select
<Upload for __sec> and enter the duration in the blank. The images of
the duration will be uploading by E-mail when the motion event occurs.
The setting range is from 1 to 9999 seconds. Select <Upload during the
trigger active> to make the images keep being uploaded to E-mail
during the trigger active until the event stops. Set the Image frequency
as the upload frame rate. The setting range is from 1 frame to 15
frames.
NOTE:
Make sure SMTP configuration has been completed.
Refer to
for further details.
