34
Select <Upload for __ sec> to set the recording duration after tampering
occurs. The setting range is from 1 to 99999 seconds.
Select <Upload during the trigger active> to record the triggered video
until the trigger is off.
NOTE:
Please make sure the local recording (with Micro SD/
SDHC card) is activated so that this function can be
implemented. Refer to
Recording
for further details.
Send Message by FTP/E-Mail
The Administrator can select whether to send an alarm message by FTP
and/or E-Mail when tampering is detected.
Upload Image by FTP
Select this item and the Administrator can assign a FTP site and
configure various parameters. When tampering is detected, event
images will be uploaded to the appointed FTP site.
<Pre-trigger buffer> function allows users to check what happened to
cause the trigger. The <Pre-trigger buffer> frame rate could be
pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain
amount of images after tampering is triggered.
Check the box <Continue image upload> to upload the triggered images
during certain time or keep uploading until the trigger is off. Select
<Upload for __sec> and enter the duration in the blank. The images of
the duration will be uploaded to FTP when tampering is triggered. The
setting range is from 1 to 9999 seconds. Select <Upload during the
trigger active> to make the images keep bei ng upload to FTP during the
trigger active until the tampering stops. Set the Image frequency as the
upload frame rate. The setting range is from 1 frame to 15 frames.
NOTE:
Make sure FTP configuration has been completed. Refer
to
FTP
for further details.
