NANO 2 – Additional Features
User Manual v2.7
www.allo.com
31
Global Outbound CID
Configure the global CallerID used for all outbound calls when no
other CallerID is defined with higher priority. If no CallerID is defined
for extension or trunk, the global outbound CID will be used as
CallerID.
Global Outbound CID
Name
Configure the global CallerID Name used for all outbound calls. If
configured, all outbound calls will have the CallerID Name set to this
name. If not, the extension's CallerID Name will be used.
Operator Extension
Specify the operator extension, which will be dialed when users
presses 0 to exit voicemail application. The operator extension can
also be used in IVR option.
Ring Timeout
Configure the number of seconds to ring an extension before the
call goes to the user's voicemail box. The default setting is 20 .
VoIP Phone Digit Map
: This option allows the administrator to define a global digit mapping
string compatible with RFC 3435. There is no default setting and this option does not sync
with the dialplan assigned to an individual user. The following examples should assist in
writing an acceptable digit mapping string.
•
[2-9]11 - Where calls beginning with digits 2-9 followed by digits 11 are dialed
immediately.
•
0T - Where calls beginning with digit 0 followed by a pause equal to the "Digit
Timeout" option.
•
+011xxx.T - Where calls beginning with the + character, followed by 011
digits and then at least three more digits before any arbitrary number is
matched, dialed after Digit Timeout is reached.
•
0[2-9]xxxxxxxxx - Where calls beginning with 0, followed by any digit from 2-
9, followed further by 9 more digits are dialed immediately.
•
+1[2-9 xxxxxxxx - Where calls beginning with the + character, followed by 1,
followed by any digit from 2-9, followed by 8 more digits are dialed
immediately.
•
[2-9]xxxxxxxxx - Where calls beginning with any digit from 2-9, followed by 9
more digits are dialed immediately.
•
[2-9]xxxT - Where calls beginning with any digit from 2-9, followed by three
more digits are dialed after Digit Timeout is reached.
•
[2-9]11|0T|+011xxx.T|0[2-9]xxx1[2-9]xxxxxxxx|[2-9]xxxxxxxxx|[2-
9]xxxT where each entry is separated by the | character. For more
information, please refer to RFC 3435.
VoIP Phone Digit Timeout
: The timeout variable is the number of seconds the phone will
wait for each segment of a digit map expressed as an integer.
Summary of Contents for Nano 2
Page 1: ...Version 2 0...
