3.2.9. Bandwidth Management
•
Function Name:
Bandwidth Management Configuration
•
Function
The Bandwidth Management function is used to set Ingress
Description
:
and Egress bandwidth limits for each port
Fig. 3.20
•
Parameter Port
Number
:
Description
:
* Select the port to which you want to add a Rate Control
Policy. Optionally, you can select to control all ports at
the same time from the “All” selection
All Traffic for Ingress Rate Limiting
:
* Define the rate for incoming traffic on the selected port.
Incoming traffic will be discarded if the rate exceeds the
value you set up in Data Rate field. Pause frames are
also generated if Flow Control is enabled (see section
3.2.2). The limited format of the packet includes unicast,
broadcast and multicast. The valid range is 0-1000.
Broadcast & Multicast for Ingress Rate Limiting
:
* Define the rate for incoming Broadcast and Multicast
traffic on the selected port. Incoming traffic will be
discarded if the rate exceeds the value you set up in the
Data Rate field. The limited format of the packet only
includes broadcast and multicast. The valid range is 0-1000
All Traffic for Egress Rate Limiting
:
* Define the rate for outgoing traffic on the selected port.
Packet transmission will be delayed if the rate exceeds
the value you set up in Data Rate field. Traffic may be
lost if egress buffers are congested. The limited format
of the packet includes unicast, broadcast and multicast.
The valid range is 0-1000.
31
Summary of Contents for 16-PORT GIGABIT WEB SMART SWITCH GSS-16T2SFP
Page 2: ...ii June 24th 20005...
Page 6: ......
