MMC1000xx User Manual
Alloy Computer Products Pty Ltd Copyright ©2011
3.3 Bandwidth
The Bandwidth Management function of the MMC1000xx is used to limit the
bandwidth a port may use when sending or receiving data. Storm Control protection can also be
configured to discard excessive broadcast, multicast, Control Packet traffic and flooded unicast and
multicast packets.
Fig. 3.9
Traffic:
Used to configure the ingress and egress rate limits allowed by the converter.
State:
Used to enable or disable bandwidth limitation.
Data Rate:
Used to set the data rate allowed by each port. For All Traffic options bandwidth
limitations can set in increments of 1Mbps.
Frame Type:
Used to configure traffic types used for Storm Control. Broadcast, IP Multicast,
Control packets and Flooded Unicast/Mulitcast packets can be selected.
Data Rate:
Configured the required amount of traffic allowed before the converter will
discard particular traffic types.
Burst Size
Configuration:
Configure the allowed packets burst size.
Apply Button:
The Apply button must be pressed after making any changes to any of the
values on this screen.
