POEGE24T User Manual
Alloy Computer Products Pty Ltd Copyright ©2012
according to IEC 61000-4-11:2004
LVD:
- EN60950-1:2006+A11:2009+A1:2010EMC:
Australian C-Tick Compliance.
This equipment is compliant with the required Australian C-Tick standards
PLEASE READ THE FOLLOWING SAFETY INFORMATION CAREFULLY BEFORE INSTALLING THE
SWITCH:
WARNING:
Installation and removal of the unit must be carried out by qualified personnel
only.
This guide is intended for use by network administrators who are responsible for
setting up and installing network equipment; consequently it assumes a basic
working knowledge of LANs (Local Area Networks).
The unit must be connected to an earthed (grounded) outlet to comply with
international safety standards.
Do not connect unit to an A.C outlet (power supply) without an earth (ground)
connection.
The appliance coupler (the connector to the unit and not the wall plug) must have a
configuration for mating with an EN 60320/IEC 320 appliance inlet.
The socket outlet must be near to the unit and easily accessible. You can only
remove power from the unit by disconnecting the power cord from the outlet.
This unit operates under SELV (Safety Extra Low Voltage) conditions according to IEC
60950. The conditions are only maintained if the equipment to which it is connected
also operates under SELV conditions.
