No Filter Operation / Water Flow
Always ensure the power has been turned on.
Check that your impeller and shaft are seated correctly and not damaged
in any way.
Ensure the impeller is free of any type of blockage and can rotate freely inside the
motor head.
Check cable for damage - if damage is evident, unplug the unit and do not use the EF.
Do not attempt to
fix, consult an electrician or other qualified person. Replace fuse
if necessary.
Check all hosing (part 7) and pipework are connected correctly, air tight a
n
d
unrestricted.
Check the EF
filter body (part 5), filter media, hosing (part 7) and all pipework for a build
up of restrictive waste and clean if required.
No Water Is Coming Out Of My Filter
Causes:
The impeller is blocked - please refer to the impeller maintenance section
above.
There is no water in the
filter body
The
filter is not switched on.
The inlet pipe is clogged.
Solutions:
Use a small jug and scoop some water from the surface of your tank a
n
d
pour into
the
filter body.
Check your
filter is plugged into the mains and is switched on.
Remove the
filter from your tank and clean the inlet pipe.
